DCFM Installation Guide (53-1001817-01, July 2010)

24 of 32 DCFM Installation Guide
53-1001817-01
SMI Agent only configuration
f. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the message to remain on
the Server Configuration screen and edit the syslog port number (return to step 5a). Click Yes to close the
message and continue with step 6.
If you enter a port number already in use, a warning displays next to the associated port number field. Edit
that port number and click Next.
6. Complete the following steps on the SMI Agent Configuration screen (Figure 10).
FIGURE 10 SMI Agent Configuration screen
The Enable SMI Agent and Enable SLP check boxes are selected by default and cannot be cleared.
a. Enable the SSL by selecting the Enable SSL check box, if necessary.
b. Enter the SMI Agent port number in the SMI Agent Port # field (default is 5989 if SSL Enabled is selected;
otherwise, the default is 5988).
c. Click Next.
7. Select one of the following options on the SAN Size screen and click Next:
NOTE
Port count is equal to the total number of switch ports across all fabrics.
• Small (managing up to 2000 ports, 1-20 domains)
• Medium (managing up to 5000 ports, 21-60 domains)
• Large (managing up to 9000 ports, 61-120 domains)
8. Verify your configuration information on the Server Configuration Summary screen and click Next.
9. Complete the following steps on the Start Server screen.
a. Select the Start SMI Agent check box, if necessary.
b. Select the Start SLP check box, if necessary.
c. Click Finish.
After all of the services (Server, SLP, and SMI Agent) are started, you can access the Server Management
Console.