DCFM Installation Guide (53-1001817-01, July 2010)

DCFM Installation Guide 23 of 32
53-1001817-01
SMI Agent only configuration
b. Select an address from the Switch - Server IP Configuration Preferred Address list.
If DNS is not configured for your network, do not select the “hostname” option from either the Server IP
Configuration or Switch - Server IP Configuration Preferred Address list. Selecting the “hostname” option
prevents clients and devices from communicating with the server.
If you select a specific IP address from the Server IP Configuration screen and the selected IP address
changes, you will not be able to connect to the server. To change the IP address, refer to “Configuring an
explicit server IP address” on page 27.
c. Click Next.
5. Complete the following steps on the Server Configuration screen (Figure 9).
NOTE
Do not use port 2638 for any of these port numbers. Port 2638 is used internally by the server.
FIGURE 9 Server Configuration screen
a. Enter a port number in the Syslog Port # field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog messages from the device.
To find and stop the process currently running on the default syslog port number, refer to “Syslog
troubleshooting” on page 25.
b. Enable SSL by selecting the SSL Enabled check box.
c. Enter a port number in the Web Server Port # field (default is 443 if SSL Enabled is selected; otherwise, the
default is 80).
d. Enter a port number in the SNMP Port # field (default is 162).
e. Enter a port number in the Starting Port # field (default is 24600).
NOTE
The server requires 16 consecutive free ports beginning with the starting port number.