Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

886 Brocade Network Advisor SAN User Manual
53-1002696-01
FC troubleshooting
28
ATTENTION
If you run more than one test per slot, the result may go wrong or the test may fail.
To run a diagnostic port test, complete the following steps.
1. Select Configure > FC Troubleshooting > Diagnostic Port Test.
The Diagnostic Port Test dialog box displays.
2. Select the ports for which you want to run a diagnostic port test from the Available Ports table.
You can only run 10 diagnostic port tests at a time. If you select more than 10 ports, the
Management application runs the first 10 diagnostic port tests and queues the rest. When the
first test is completed, the next test in the queue begins and so on until all tests are completed.
3. Click the right arrow button to move the ports to the Selected Ports table.
4. To configure parameters for the link traffic test, select the ports for which you want to configure
link traffic test in the Selected Ports table and click Link Traffic Test.
Refer to “Configuring link traffic test parameters” on page 889.
5. Click Start.
The Management application performs the following operations to enable diagnostic mode on
the selected ports:
1. Disable the source port.
2. Disable the destination port.
3. Enable the diagnostic mode on source E-port.
4. Enable the diagnostic mode on destination E-port.
5. Enable the source port.
6. Enable the destination port.
The following tests are performed on the selected ports:
The following tests are performed on the selected ports:
• Electrical loopback (16 Gbps only)
• Optical loopback (16 Gbps only)
TABLE 77 D-Port test support matrix
D-Ports Tests Fabric OS 7.0 Fabric OS 7.1 HBA driver 3.2
E-Port E-Port F-Port AG N-Port ICL-Port
Electrical Test
Supported Supported Supported Supported Not supported Supported
Optical Test
Supported Supported Supported Supported Not supported Not supported
Link
Traffic
Test
Configuration
Not supported Supported Supported Supported Supported Not supported
Test
Supported Supported Supported Supported Supported Not supported
Link Distance
Supported Supported Supported Supported Supported Not supported
Link Measurement
Not supported Not supported Supported Supported Supported Not supported