Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 839

53-1002696-01

Deleting an Allow/Prohibit Matrix configuration

NOTE

If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of

possible causes.

You cannot delete the active configuration, the IPL configuration, or a configuration that is marked

as having uncommitted changes.

1. Select Configure > Allow/Prohibit Matrix.

The Configure Allow/Prohibit Matrix dialog box displays.

2. Select the Allow/Prohibit Matrix configuration you want to delete. You can do this by expanding

the view for the switch under Available Switches and selecting a configuration, or you may

select the matrix under Allow/Prohibit Matrix.

3. Click Delete.

A confirmation message displays.

4. Click Yes to confirm.

Changing the Allow/Prohibit Matrix display

You can modify the display using the Window Arrangement list above the matrix display or the Clear

all port names option below the display.

NOTE

If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of

possible causes.

Changing window arrangement

There are three options for the Allow/Prohibit Matrix display on the Configure Allow/Prohibit Matrix

dialog box located in the Window Arrangement list above the display.

• The matrix definitions may be cascaded (this is the default view).

• The matrix definitions may be tiled horizontally.

• The matrix definitions may be tiled vertically.

Perform the following steps to change the display to the desired format.

1. Select Configure > Allow/Prohibit Matrix.

The Configure Allow/Prohibit Matrix dialog box displays.

2. Select Cascade, Tile Horizontally, or Tile Vertically from the Window Arrangement list.