Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 691

53-1002696-01

Viewing time left for auto rekey

You can view the time remaining until auto rekey is no longer active for a disk LUN. The information

is expressed as the difference between the next rekey date and the current date and time, and is

measured in days, hours, and minutes.

Although you cannot make changes directly to the table, you can modify the time left using CLI. For

more information, see the administrator’s guide supporting your key vault management system.

To view the time left for auto rekey, follow these steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 185 on page 526.)

2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the

auto rekey information, then select Group/Switch/Engine > Targets from the menu task bar.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays. (Refer to Figure 293.)

3. Select a target disk device from the table, then click LUNs.

The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is

listed in the table (Figure 325).

FIGURE 325 Encryption Targets Disk LUNs dialog box - Time left for auto rekey