Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 649
53-1002696-01
Configuring hosts for encryption targets
20
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays (Figure 293).
FIGURE 293 Encryption Targets dialog box
3. Select a target storage device from the list, then click Hosts.
The Encryption Target Hosts dialog box displays (Figure 294). The Hosts in Fabric table lists the
configured hosts in a fabric.
The table displays the following information:
• Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
• Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
• Port Name: The name of the hosts that are in the same fabric as the encryption engine.
• Port ID: Displays the 24-bit port ID (PID) of the host port in both the Host Ports in Fabric
table and the Selected Hosts table.
FIGURE 294 Encryption Target Hosts dialog box