Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

644 Brocade Network Advisor SAN User Manual

53-1002696-01

Configuring encryption storage targets

FIGURE 288 Select Hosts dialog box

The dialog box contains the following information:

• Hosts in Fabric table: Lists the available hosts in the fabric.

• Selected Hosts table: Lists the hosts that have been selected to access the target.

• Port WWN: The world wide name of the host ports that are in the same fabric as the

encryption engine.

• Node WWN: The world wide name of the host nodes that are in the same fabric as the

encryption engine.

• Port Name: The user-assigned port name, if one exists; otherwise, the symbolic port name

from the device.

• Port ID: The 24-bit Port ID of the host port.

• VI Port WWN: The world wide name of the virtual initiator port.

• VI Node WWN: The world wide name of the virtual initiator node.

• Host Name: The name of the hosts that are in the same fabric as the encryption engine.

• Port WWN text box: Type a world wide name for a host port.

NOTE

Note: You must enter the host node world wide name before clicking Add, to add the WWN

to the Selected Hosts table.

• Node WWN text box: Type a world wide name for a host node.

NOTE

Note: You must also enter the host port world wide name before clicking Add to add the

node WWN to the Selected Hosts table.

• Device Type: The device type indicated by the fabric’s name service. The value is either

Initiator or Initiator + Target.