Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

608 Brocade Network Advisor SAN User Manual
53-1002696-01
Creating a new encryption group
20
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See “Understanding configuration status
results” on page 629 for more information.
8. Verify the information is correct, then click Next.
The Next Steps dialog box displays (Figure 247). Instructions for installing public key
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
FIGURE 247 Next Steps dialog box
9. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
then click Finish to exit the Configure Switch Encryption wizard.
10. Refer to “Understanding configuration status results” on page 629.