Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

604 Brocade Network Advisor SAN User Manual
53-1002696-01
Creating a new encryption group
20
Configuring key vault settings for NetApp Link Key Manager
(LKM/SSKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to “Creating a new encryption group”
on page 592.
Figure 242 shows the key vault selection dialog box for LKM/SSKM.
FIGURE 242 Select Key Vault dialog box for LKM/SSKM
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault’s public key certificate, or browse to
the desired location.
3. If you are using a backup key vault, enter the IP address or host name, and the name of the file
holding the backup key vault’s public key certificate, then click Next.
The Specify Public Key Certificate (KAC) File Name dialog box displays (Figure 243).