Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 589

53-1002696-01

Steps for connecting to a KMIP appliance (SafeNet KeySecure)

Adding a node to the cluster

Perform the following steps on the secondary KeySecure node when adding it to the cluster.

1. From the KeySecure Management Console, select the Device tab, then select Device

Configuration > Cluster.

The Cluster Configuration page displays (Figure 226).

FIGURE 226 KeySecure Cluster Configuration page

2. Under Join Cluster, enter the cluster information that you configured for the primary KeySecure

node. (Refer to “Creating a cluster” on page 582.)

3. Enter the primary KeySecure node IP address and port number in the respective Cluster

Member IP and Port fields.

4. Enter the Cluster Key File or browse to the file location.

5. Enter the Cluster Password, then click Join.

You are returned to the Cluster Configuration page with the cluster information listed in the

Cluster Members table (Figure 227).

6. Verify that both KeySecure nodes are shown as Active.