Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 443
53-1002696-01
DCB Configuration
16
Creating a DCB map to carry the LAN and SAN traffic
To create a DCB map to carry the LAN and SAN traffic, complete the following steps.
NOTE
This procedure is applicable for Fabric OS versions earlier than Fabric OS 7.0. For Fabric OS versions
7.0 and later, you can only edit the the default DCB map.
1. Select Configure > DCB.
The DCB Configuration dialog box displays.
2. Select the switch to edit from the Products/Ports list and click Edit.
The Edit Switch dialog box displays.
3. Click the QoS tab.
The Edit Switch dialog box - QoS tab displays, as shown in Figure 151.
FIGURE 151 Edit Switch dialog box - QoS tab
4. Select DCB from the Map Type list.
5. Configure the following DCB Map parameters in the DCB Map area:
• Name - Enter a name to identify the DCB map.
• Precedence - Enter a value between 1 through 100. This number determines the map’s
priority.
• Priority Flow Control check box - Check to enable priority-based flow control on individual
priority groups.