Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

1258 Brocade Network Advisor SAN User Manual
53-1002696-01
Database tables and fields
H
BFD_TRANSMIT This object specifies the minimum interval, in
milliseconds, that the local system would like to use
when transmitting The Bidirectional Forwarding
Detection(BFD) Control packets. Accepts a range of
50-30000.
int
BFD_RECEIVE This object specifies the minimum interval, in
milliseconds, between received Bidirectional
Forwarding Detection (BFD) Control packets the local
system is capable of supporting. Accepts a range of
50-30000.
int
BFD_MULTIPLIER The Bidirectional Forwarding Detect time multiplier.
Accepts a range of 3-50.
int
COS The Class of Service for this LSP. Allowed range is 0-7
and 255. 255 means COS is not explicitly configured.
smallint
HOP_LIMIT Represents the limit for the number of hops the LSP
can traverse. Accepted range is 0-255.
num (3,0)
IS_CSPF Specifies whether the Constrained Shortest Path First
(CSPF) calculation is enabled. Possible values are
Disabled-0, Enabled-1.
num (1,0)
MTU Specifies the Maximum IP Packet Size of the packets
without being fragmented. Valid range is 0-65535.
num (4,0)
SETUP_PRIORITY The setup priority of the tunnel. Valid range is 0-7. num (1,0)
HOLD_PRIORITY The holding priority of the tunnel. Valid range between
0-7.
num (1,0)
IS_RECORD_ROUTES Specifies whether the route is actually recorded route
or not. Not Recorded-0 and Recorded-1.
num (1,0)
REOPTIMIZE_TIMER The number of seconds from the beginning of one
reoptimization attempt to the beginning of the next
attempt. Valid range is 300-65535 seconds. 0 is also
accepted.
int
MPLS_LSP_DB_ID Database ID of the MPLS_RSVP_LSP instance which
these parameters are associated with.
int
MPLS_RSVP_LSP_PATH_DB_ID Database ID of the MPLS_RSVP_LSP_PATH instance
which these parameters are associated with.
int
TABLE 220 MPLS_RSVP_LSP_PATH
Field Definition Format Size
MPLS_RSVP_LSP_PATH_DB_ID Unique database generated identifier. int
PATH_TYPE The type of path that is active, i.e., a primary path, a
standby path, or a generic secondary path. Possible
values are Other-1, Primary-2, Standby-3 and
Secondary-4.
smallint
IS_STANDBY Specifies whether the path is standby or not. Currently
it is unused and value is always 0 (Not standby)
num (1,0)
TABLE 219 MPLS_RSVP_LSP_PARAMETERS (Continued)
Field Definition Format Size