Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

1000 Brocade Network Advisor SAN User Manual
53-1002696-01
Event action definitions
32
• > – Greater than
• >= – Greater than or equal to
• <= – Less than or equal to
• In – Matches collection
• Not_in – Does not match collection
• ~ – Arbitrary Unicode regular expression
5. Enter the value of the varbind. The value you enter must conform to the data type required by
the varbind. For example, if the varbind expects an integer and you enter a text string, your
entry will be rejected. Alternatively, you can select values from drop-down lists, as shown in
Figure 435.
6. Click Next.
The Sources pane of the Add Event Action dialog box displays. Proceed to “Selecting source
address products and ports”.
Selecting source address products and ports
The Sources pane of the Add Event Action dialog box, shown in Figure 436, allows you to enter the
IP address, the world wide name, or the name of the source to use as event senders. Alternatively,
you can select source address products to use as event senders from the available list of sources.
You can select from the available list of SAN products, IP products, or hosts by selecting the
appropriate tab.
FIGURE 436 Sources pane of the Add Event Action dialog box
Perform the following steps to configure the identity of the source.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.
2. Click Next to advance to the Sources pane.