Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

964 Brocade Network Advisor SAN User Manual

53-1002696-01

Policy monitor scheduling

c. Select the Check for connections through two fabrics to each target LUN check box to

determine if there are redundant connections between the host group and the target LUN.

For more information about this check and a fix for rule violations, refer to “Host policy

monitors” on page 955.

d. Select the hosts to which you want to apply this policy in the Available Hosts list and click

the right arrow button.

NOTE

You can use the All Host target in the Available Hosts list for future provisioning. Select All

Hosts and click the right arrow button to apply this policy to all discovered hosts.

The selected hosts display in the Selected Hosts list.

9. To set policy monitors for the Management application (Figure 416), complete the following

steps.

FIGURE 416 Add Policy Monitor dialog box, Management Checks tab

a. Select the Management Checks tab.

b. Select the Check to see if the server backup is enabled and working check box to

determine the following configurations:

• Backup enabled for the Management application server.

• Backup output directory is accessible and writable.

This policy only applies to scheduled backup, not manual (on demand) backup.

For more information about this check and a fix for rule violations, refer to “Management

policy monitor” on page 956.

10. Click OK on the Add Monitor dialog box.

The Policy Monitor dialog box displays with the new policy monitor in the Monitors list.

11. Click Close on the Policy Monitor dialog box.

Policy monitor scheduling

You can schedule a policy monitor to run automatically. For step-by-step instructions, refer to the

following procedures:

• “Configuring a one-time policy monitor schedule” on page 965

• “Configuring an hourly policy monitor schedule” on page 965

• “Configuring a daily policy monitor schedule” on page 965

• “Configuring a weekly policy monitor schedule” on page 966

• “Configuring a monthly policy monitor schedule” on page 966