HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing Application Recovery Manager on Microsoft Cluster Server
Chapter 246
Application Recovery Manager from the same node on which it was
installed, when you decide to remove Application Recovery Manager
from the system.
On Windows x64 operating systems, AutoPass is not installed.
Click Finish to complete the installation.
Checking the
Installation
When the setup procedure has been completed, you can check whether or
not the Application Recovery Manager software has been properly
installed. Proceed as follows:
1. Check if the Cluster service account is assigned to the Application
Recovery Manager Inet service on each cluster node. Make sure the
same user is also added to the Application Recovery Manager admin
user group. The logon account type should be set to This account as
shown in Figure 2-21.
Figure 2-21 Application Recovery Manager User Account
2. Switch to the <AppRM_home>\bin directory and run the following
command:
omnirsh <host> INFO_CLUS