HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing Application Recovery Manager Clients
Chapter 236
3. Enter the name of the Cell Manager. Refer to Figure 2-14.
If your Cell Manager uses a different port then the default 5555,
change the port number. You can test if the Cell Manager is active
and uses the selected port by clicking Check response...
Click Next.
Figure 2-14 Choosing the Cell Manager
4. Click Next to install Application Recovery Manager on the default
folder.
Otherwise, click Change to open the Change Current Destination
Folder page and enter the path.
5. Select the Application Recovery Manager components that you want
to install.
For information on other Application Recovery Manager components,
refer to “Application Recovery Manager Components” on page 28.
Click Next.
6. Windows 2003 SP1: If Application Recovery Manager detects
Windows Firewall on your system, the Windows Firewall
configuration page is displayed. Application Recovery Manager setup
will register all necessary Application Recovery Manager executables.
By default, the selected option is Initially, enable newly