HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing the Application Recovery Manager Cell Manager (CM) and Installation
Server(s) (IS)
Chapter 222
“Setting Up the TCP/IP Protocol on Windows Systems” on page B-20
for information on the installation and configuration of the TCP/IP
protocol.
Limitation Due to the security restrictions imposed by the Windows operating
system, Installation Server can be used to remotely install clients only in
the same domain.
IMPORTANT If you do not install the Installation Server on your network, you will
have to install every client locally from the CD-ROM.
NOTE You cannot remotely install an Application Recovery Manager client on
the system after an Installation Server has been installed on this system.
To install an Installation Server and client component(s) on the same
system, you must perform a local client installation. During the
installation procedure, select all desired client components and the
Installation Server component. Refer to “Installing Application Recovery
Manager Clients” on page 26.
Installation
Procedure
Follow these steps to install the Installation Server:
1. Insert the installation CD-ROM and run:
32-bit OS (on x86 or AMD64/Intel EM64T): \i386\setup.exe
64-bit OS (on AMD64/Intel EM64T): \x8664\setup.exe
The Application Recovery Manager Setup Wizard is displayed.
2. Follow the Setup Wizard and carefully read the license agreement.
Click Next to continue, if you accept the terms of the agreement.
3. In the Installation Type page, select Installation Server and
then click Next to install Application Recovery Manager software
depot.