HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing the Application Recovery Manager Cell Manager (CM) and Installation
Server(s) (IS)
Chapter 2 21
✓ Disk Space
✓ Administrative Rights
What’s Next?
At this stage, the Cell Manager is installed and – if it was selected – also
the Installation Server. Your next tasks are:
1. Install the Installation Server, if you have not installed it on the same
system as the Cell Manager. Refer to “Installing Installation Servers”
on page 21.
2. Distribute the software to clients. Refer to “Installing Application
Recovery Manager Clients” on page 26.
Installing Installation Servers
Installation Servers can be installed on the Cell Manager system or any
supported system that is connected to the Cell Manager by a LAN. See
the http://www.hp.com/support/manuals
for details on supported
operating systems for the Installation Server.
To keep the Installation Servers on systems separate from the Cell
Manager, install the corresponding software depot locally. The detailed
procedure is described in this section.
Prerequisites A Windows system that will become your future Installation Server must
meet the following requirements:
✓ Have one of the supported Windows operating systems installed. See
the http://www.hp.com/support/manuals
for details on supported
operating systems for the Installation Server.
✓ Have Microsoft Internet Explorer 5.0 or higher.
✓ Have enough disk space for the complete Application Recovery
Manager software depot. Refer to the HP StorageWorks Application
Recovery Manager Release Notes for details.
✓ Have access to a CD-ROM drive.
✓ Have the Microsoft implementation of the TCP/IP protocol up and
running. The protocol must be able to resolve hostnames. The
computer name and the hostname must be the same. Refer to