HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing the Application Recovery Manager Cell Manager (CM) and Installation
Server(s) (IS)
Chapter 220
After the Installation
As soon as the setup is finished, the Cell Manager files are located in the
<AppRM_home>\bin directory and the software depot located in the
<AppRM_home>\Depot directory.
When the installation is finished, the following processes will be running
on the Cell Manager system in the <AppRM_home>\bin directory:
crs.exe The Application Recovery Manager
Cell Request Server (CRS) service
runs on the Cell Manager system and
is started when the Cell Manager
software is installed on the system.
CRS starts and controls backup and
restore sessions in the cell.
rds.exe The Application Recovery Manager
Raima Database Server (RDS)
service runs on the Cell Manager
system and is started when the Cell
Manager software is installed on the
system. RDS manages the IDB.
omniinet.exe The Application Recovery Manager
resident service that enables
communication with Application
Recovery Manager services on other
systems on the network. The
Application Recovery Manager
Inet service must run on all systems
in the Application Recovery Manager
cell.
Troubleshooting
In case of an unsuccessful setup, try to verify the requirements that are
checked by Setup itself and what could have caused the failure if they
had not been fulfilled. Refer to the “Prerequisites” on page 14.
This is the list of the requirements checked by Setup:
✓ Operating system version
✓ NSLookup, so that Application Recovery Manager is able to expand
hostnames