HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Application Recovery Manager Licensing
Application Recovery Manager Passwords
Chapter 490
Application Recovery Manager Passwords
Once you have installed Application Recovery Manager product, you can
start using it for 60 days. After this period, you must install a permanent
password on the Cell Manager to enable the software. You may load the
software on the Application Recovery Manager Cell Manager, but you
cannot perform configuration tasks without a permanent password,
because the licenses required for particular Application Recovery
Manager functionality require passwords.
The Application Recovery Manager licensing requires one of the
following passwords:
✓ Instant-On password
An Instant-On password is built in the product when first installed.
You are able to use the software for 60 days after you have installed it
on any system supported by Application Recovery Manager. Within
this period you must request your permanent password from the HP
Password Delivery Center (PDC) and then install it.
✓ Permanent passwords
The Application Recovery Manager product is shipped with an
Entitlement Certificate license that entitles you to obtain a
permanent password. The permanent password permits you to
configure an Application Recovery Manager cell with regard to your
backup policy, provided that you have bought all required licenses.
Before you request a permanent password, you must determine the
Cell Manager system and understand your cell configuration
requirements.
✓ Emergency password
Emergency or fallback passwords are available in case the currently
installed passwords do not match the current system configuration
due to an emergency. They will allow operation on any system for a
duration of 120 days.