HP StorageWorks Application Recovery Manager Administrator's Guide (T4395-96004, February 2008)

Configuration
Configuring HP StorageWorks Enterprise Virtual Array
Chapter 224
Removing a
Management
System
To remove a management system from a list of systems on which CV
EVAs are running, with its login and port number information, from the
SMISDB, run:
omnidbsmis -ompasswd -remove <hostname> [-port
<port_number>] [-namespace <namespace>] [-user <username>]
Used together with the -port port option, the command will only
remove the entries for the specified port. Use this option if you have more
than one port configured on the same system, and you want to delete
only one port from the configuration.
If the -namespace namespace option is specified, the command will only
remove the entries for the specified namespace. Use this option if you
have more than one namespace configured on the same system, and you
want to delete only one namespace from the configuration.
If the -user username option is specified, the command will only remove
the entries for the specified user. Use this option if you have more than
one user configured on the same system, and you want to delete only one
user from the configuration.
Getting a List of
Configured
CIMOMs
To get a list of all SMI-S CIMOMs, together with the port numbers, that
are configured in the Application Recovery Manager cell, run:
omnidbsmis -ompasswd -list [<hostname>]
The <hostname> value is optional: if you enter a name of the host, only
the SMI-S CIMOMs, configured for the specified host, will be displayed.
Checking the
CIMOM Login
Configuration
Before a backup or restore session, you can check if the SMI-S CIMOMs
were configured properly in the Application Recovery Manager cell. To
perform a health check of you environment, which may help identify
such potential problems as wrong user name or password provided, a
broken network connection, a DNS resolution problem, run:
omnidbsmis -ompasswd -check [<hostname>]
The <hostname> value is optional: if you enter a name of the host, the
command will be run on the specified host, otherwise it will be run on the
local host. Note that HP StorageWorks SMI-S Agent must be installed on
the specified host.
Considerations If a failover from the active to the standby management system happens,
proceed as follows: