HP Application Recovery Manager software Integration guide (March 2008)

3. In the Source property page, specify writers and/or components for recovery.

Select the configuration check mode. For more information, see

“Configuration check” on page 43.

To perform additional steps after the instant recovery before recovering the

database, such as restoring logs backed up using third–party backup software,

select the No recovery option. Application Recovery Manager will not perform

a database recovery and you can finish the recovery steps (such as applying

transaction logs) later on manually.

If the option is not selected, all recovery steps are finished. In such a case,

additional tasks cannot be performed.

This option is available only for the SQLServer writer and Microsoft Exchange

Server 2007 writer. It is not supported for Microsoft Exchange writer, where the

transaction logs are always applied when the store is mounted.

Exchange Server Writer: Optionally, to specify options for the consistency check

of a Microsoft Exchange writer, right-click the writer and click Additional options.

You can perform point-in-time or rollforward restore of Microsoft Exchange Server

writer. For more information, see

“Microsoft Exchange Server writer recovery specifics” on page 65.

Exchange Server 2007 Writer:

If you restore an LCR or CCR copy to the original location, note that restore will

be performed to the original database (Exchange Information Store) and not to

the database copy (Exchange Replication Service).

To perform restore to a different location:

a. Right-click a storage group, a store, or logs and click Restore as.

b. In the MS Exchange Additional options dialog box, select the target location

for the components you want to restore: target server, target storage group,

and target stores. The following options are possible:

• Restore to a different store

This option is selected by default. It enables you to select the target stores

for each store to be restored (original stores). Select the target server

first and then from the Original and Target drop-down list, select the

stores pairs. For example, to restore only one store, select only one

target store for the original store you want to restore. Note that only

stores cannot be restored, so logs are automatically selected in the

restore session to different location.

• Restore to a non-Exchange location

Integrating the Application Recovery Manager ZDB integrations and Microsoft Volume

Shadow Copy Service