HP Application Recovery Manager software Integration guide (March 2008)

• Do not manually mount target volumes that have been created by Application

Recovery Manager.

Configuring HP StorageWorks Enterprise Virtual Array

This section describes how to configure the Application Recovery Manager HP

StorageWorks Enterprise Virtual Array (EVA) integration for use with the VSS

integration.

Prerequisites

• Install

HP storage components and licenses:

• HP StorageWorks Virtual Controller Software (VCS or XCS) and Command

View (CV) EVA. See the VCS and CV EVA documentation for installation

instructions. See the support matrices on the web for information on supported

product versions.

• HP Operations Manager software (HP StorageWorks SMI-S EVA provider

part).

• HP StorageWorks Business Copy (BC) EVA microcode and license.

• If the alternate paths solution is used, install HP MPIO DSM for EVA.

• An EVA license for, at least, basic and snapshot operation.

• Install

Application Recovery Manager components and licenses:

• An instant recovery license.

• HP StorageWorks EVA SMI-S Agent.

For installation and licensing information, see the HP Application Recovery

Manager software installation and licensing guide.

• Make sure the same operating system (and its version) is installed on the

application and backup systems.

• Connect EVA to the application and backup systems through the SAN. Backup

system must be connected to the same SAN as the EVA.

For supported backup and connectivity topologies, see HP Application Recovery

Manager software administrator's guide.

For general Application Recovery Manager and integration-specific limitations, see

HP Application Recovery Manager software product announcements, software notes,

and references.

Integrating the Application Recovery Manager ZDB integrations and Microsoft Volume

Shadow Copy Service