HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

1. Check if the Cluster service account is assigned to the Application Recovery
Manager Inet service on each cluster node. Make sure the same user is also
added to the Application Recovery Manager admin user group. The logon
account type should be set to This account as shown in and
Figure 25 on page 88.
Figure 25 Application Recovery Manager user account
2. Switch to the AppRM_home\bin directory and run the following command:
omnirsh host INFO_CLUS
where host is the name of the cluster virtual server (case-sensitive). The output
should list the names of the systems within the cluster and the name of virtual
server. If the output returns 0 “NONE”, Application Recovery Manager is not
installed in the cluster-aware mode.
3. Start the Application Recovery Manager GUI, select the Clients context, and
then click MS Clusters. You should see the newly installed systems listed in the
Results Area.
Installing Application Recovery Manager on your network88