HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)
9. The Installation setup page is displayed. Click Next.
Figure 24 Installation status page
10. To start Application Recovery Manager immediately after install, select Start the
Application Recovery Manager GUI.
To view the HP Application Recovery Manager software product announcements,
software notes, and references, select Open the Product Announcements.
On operating systems other than 64-bit Windows (x64, IA-64), to install the HP
OpenView AutoPass utility, select the Start AutoPass installation or the Upgrade
AutoPass installation option.
It is not recommended to install the HP OpenView AutoPass utility in Microsoft
Cluster, because it will be installed only on the node used for the installation. If
you did install AutoPass, you must uninstall Application Recovery Manager from
the same node on which it was installed, when you decide to remove Application
Recovery Manager from the system.
On 64-bit Windows operating systems, AutoPass is not installed.
Click Finish to complete the installation.
Checking the installation
When the setup procedure has been completed, you can check whether or not the
Application Recovery Manager software has been properly installed. Proceed as
follows:
Installation and licensing guide 87