HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

• If the virtual server does not exist in the same group as the File Share resource
group, a new virtual server must be created using a free registered IP address
and associating a network name with it.
• The File Share resource where Application Recovery Manager is to be installed
must have the IP Address, Network Name, and Physical Disk set among the File
Share dependencies. This is necessary to ensure that Application Recovery
Manager cluster group will be able to run on any node independently of any
other group.
• Ensure that only the cluster administrator has access to the File Share resource
and that he has full access to it.
• Each system of the cluster should be up and running properly.
• If a system in the cluster has the Application Recovery Manager software installed
as non-cluster-aware, you need to uninstall it prior to the setup.
• Application Recovery Manager must be installed on the same location (drive and
pathname) on all cluster nodes. Ensure that these locations are free.
• Other Microsoft Installer based installations must not be running on other cluster
nodes.
Local installation
The Application Recovery Manager cluster-aware Cell Manager software must be
installed locally, from the CD-ROM. This can be done as follows:
1. Insert the installation CD-ROM and run:
32-bit Windows (on x86 or AMD64/Intel EM64T): \i386\setup.exe
64-bit Windows (on AMD64/Intel EM64T): \x8664\setup.exe
The Application Recovery Manager Setup Wizard displays.
2. Follow the Setup Wizard and carefully read the license agreement. Click Next
to continue, if you accept the terms of the agreement.
Installation and licensing guide 83