HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

3. Enter the name of the Cell Manager. Refer to Figure 18 on page 68.
If your Cell Manager uses a different port then the default 5555, change the
port number. You can test if the Cell Manager is active and uses the selected
port by clicking Check response...
Click Next.
Figure 18 Choosing the Cell Manager
4. Click Next to install Application Recovery Manager on the default folder.
Otherwise, click Change to open the Change Current Destination Folder page
and enter the path.
5. Select the Application Recovery Manager components that you want to install.
For information on other Application Recovery Manager components, refer to
Application Recovery Manager components on page 64.
Click Next.
Installing Application Recovery Manager on your network68