HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

NOTE:
Before you start using the Application Recovery Manager GUI on the client system, add
a user from that system to an appropriate Application Recovery Manager user group.
For the procedure and the descriptions of available user rights, refer to the online Help.
Troubleshooting
When the remote installation is finished, you can restart any failed installation
procedures using the GUI by clicking Actions and Restart Failed Clients. If the
installation fails again, see Chapter 6 on page 149.
Adding components to clients
You can install additional Application Recovery Manager software components on
your existing clients and the Cell Manager. Components can be added remotely or
locally. For local installation, see
“Changing Application Recovery Manager software components” on page 117.
Prerequisite
The Installation Server must be available.
To distribute the Application Recovery Manager software to clients in the Application
Recovery Manager cell, proceed as follows:
1. In the Application Recovery Manager GUI, switch to the Clients context.
2. In the Scoping Pane, expand Clients, right-click a client, and then click Add
Components.
3. If you have more than one Installation Server configured, select the platform of
the clients on which you want to install the components (UNIX or Windows) and
the Installation Server to be used for installing the components. Click Next.
Installing Application Recovery Manager on your network62