HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

7. The Installation status page is displayed. Click Next.
Figure 13 Installation status page
8. Click Finish.
As soon as the installation is finished, the software is, by default, installed in the
AppRM_home\Depot directory, which is shared so that it can be accessed from the
network.
What’s next?
At this point, you should have Installation Server installed on your network. Now you
should perform the following tasks:
1. If you have set up an independent Installation Server (i.e. not on the Cell
Manager) you must manually add (import) the system to the Application Recovery
Manager cell. Refer to “Importing an installation server to a cell ” on page 93.
2. Install an Installation Server for UNIX on HP-UX if you have a mixed backup
environment. Refer to “Installing Installation Servers for UNIX” on page 48.
3. Distribute the software to clients. Refer to
“Installing Application Recovery Manager clients” on page 57.
Installing Application Recovery Manager on your network56