HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Limitation
Due to the security restrictions imposed by the Windows operating system, Installation
Server can be used to remotely install clients only in the same domain.
IMPORTANT:
If you do not install the Installation Server for Windows on your network, you will have
to install every Windows client locally from the CD-ROM.
NOTE:
You cannot remotely install an Application Recovery Manager client on the system after
an Installation Server has been installed on this system. To install an Installation Server
and client component(s) on the same system, you must perform a local client installation.
During the installation procedure, select all desired client components and the Installation
Server component. Refer to “Installing Application Recovery Manager clients” on page 57.
Installation procedure
Follow these steps to install the Installation Server:
1. Insert the Windows installation CD-ROM and run:
32-bit Windows (on x86 or AMD64/Intel EM64T): \i386\setup.exe
64-bit Windows (on AMD64/Intel EM64T): \x8664\setup.exe
The Application Recovery Manager Setup Wizard is displayed.
2. Follow the Setup Wizard and carefully read the license agreement. Click Next
to continue, if you accept the terms of the agreement.
Installation and licensing guide 53