HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

• NSLookup, so that Application Recovery Manager is able to expand hostnames
• Disk Space
• Administrative Rights
What’s next?
At this stage, the Cell Manager is installed and – if it was selected – also the
Installation Server. Your next tasks are:
1. Install the Installation Server, if you have not installed it on the same system as
the Cell Manager. Refer to “Installing Installation Servers” on page 48.
2. Distribute the software to clients. Refer to
“Installing Application Recovery Manager clients” on page 57.
Installing Installation Servers
Installation Servers can be installed on the Cell Manager system or any supported
system that is connected to the Cell Manager by a LAN. See the http://www.hp.com/
support/manuals for details on supported operating systems for the Installation Server.
To keep the Installation Servers on systems separate from the Cell Manager, install
the corresponding software depot locally. The detailed procedure is described in this
section.
Installing Installation Servers for UNIX
Prerequisites
The system that will become your Installation Server must meet the following
requirements:
• Have the HP-UX operating system installed. For details on supported operating
systems for the Installation Server, refer to the HP Application Recovery Manager
software product announcements, software notes, and references.
• Have the inetd daemon up and running.
• Have the port number 5555 (default) free. If this is not the case, refer to the
“Changing the default port number” on page 177.
• Have the TCP/IP protocol installed and running. The protocol must be able to
resolve hostnames.
Installing Application Recovery Manager on your network48