HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Figure 10 Selecting AutoPass for installation
Click Finish.
After the installation
As soon as the setup is finished, the Cell Manager files are located in the
AppRM_home directory and the software depot located in the AppRM_home\Depot
directory.
When the installation is finished, the following processes will be running on the Cell
Manager system:
crs.exe The Application Recovery Manager Cell Request
Server (CRS) service runs on the Cell Manager
system and is started when the Cell Manager
software is installed on the system. CRS starts and
controls backup and restore sessions in the cell.
It runs in the AppRM_home\bin directory.
rds.exe The Application Recovery Manager Raima
Database Server (RDS) service runs on the Cell
Manager system and is started when the Cell
Manager software is installed on the system. RDS
manages the IDB. It runs in the AppRM_home\bin
directory.
omniinet.exe The Application Recovery Manager client service
that enables the Cell Manager to start agents on
other systems. The Application Recovery
Manager Inet service must run on all systems
in the Application Recovery Manager cell. It runs
in the AppRM_home\bin directory.
Troubleshooting
In case of an unsuccessful setup, try to verify the requirements that are checked by
Setup itself and what could have caused the failure if they had not been fulfilled.
Refer to the Prerequisites on page 39.
This is the list of the requirements checked by Setup:
• Operating system version
Installation and licensing guide 47