HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Installation procedure
TIP:
If you install the Cell Manager and Installation Server on the same system, you can
perform the installation in one step by running omnisetup.sh -CM -IS.
For a description of the omnisetup.sh command, refer to the README file located in
the Mount_point/LOCAL_INSTALL directory on the CD-ROM or to the
HP Application Recovery Manager software command line interface reference located
in the Mount_point/DOCS/C/MAN directory on the CD-ROM.
Follow the procedure below to install the Cell Manager on an HP-UX system:
1. Insert and mount the UNIX installation CD-ROM to a mount point.
For example:
mkdir /cdrom
mount /dev/dsk/c0t0d0 /cdrom
Optionally, you can install Application Recovery Manager from a depot on the
disk:
• To copy the APPRM_DEPOT, AUTOPASS, and LOCAL_INSTALL directories,
where the installation files are stored, to your local disk, run:
mkdir directory
cp -r /cdrom/APPRM_DEPOT directory
cp -r /cdrom/AUTOPASS directory
cp -r /cdrom/LOCAL_INSTALL directory
• To copy the whole CD-ROM to your local disk, run:
cp -r /cdrom cd_image_dir
Installing Application Recovery Manager on your network34