HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

On UNIX
On a UNIX Cell Manager, do the following:
1. Change the Cell Manager hostname entries in the following files:
/etc/opt/omni/client/cell_server
/etc/opt/omni/server/users/UserList
2. Verify that Name Resolution works among the members of an Application
Recovery Manager cell.
3. Change the Cell Manager name in the IDB by running:
/opt/omni/sbin/omnidbutil -change_cell_name [old_host]
On Windows
On a Windows Cell Manager, do the following:
1. Change the Cell Manager hostname entries in the following files:
AppRM_home\config\server\cell\cell_info
AppRM_home\config\server\users\userlist
2. Change the Cell Manager name in the following registry key:
\\HKEY_LOCAL_MACHINE\SOFTWARE\Hewlett-Packard\
OpenView\OmniBack\Site\CellServer
Changing the default port number
The Application Recovery Manager Inet service (process), which starts other
processes needed for backup and restore, should use the same port number on each
system within the cell.
By default, Application Recovery Manager uses the port number 5555. To verify that
this particular port number is not used by another program, you should view the
/etc/services file on UNIX systems or run the netstat -a command on
Windows systems. If the port number 5555 is already in use by another program,
you must change this value to an unused port number. If the port number is not
available only on client systems, you can change it after installing the Cell Manager.
If the port number is not available on the system where you want to install the Cell
Manager, you must change the port number before the installation.
Installation and licensing guide 177