HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

5. From the Actions menu, click Install (analysis). Click OK to proceed.
When the installation is finished, the software depot for UNIX is located in the
/opt/omni/databases/vendor directory.
IMPORTANT:
If you do not install the Installation Server for UNIX on your network, you will have to
install every UNIX client locally from the UNIX installation CD-ROM.
Installing the clients
The clients are not installed during a Cell Manager or Installation Server installation.
The clients must be installed either by using omnisetup.sh or by pushing the
installation components from the Application Recovery Manager GUI. For detailed
information on how to install the clients, refer to
“Installing Application Recovery Manager clients” on page 57.
Setting up the TCP/IP protocol on Windows systems
IMPORTANT:
Only the Microsoft implementation of the TCP/IP protocol is supported.
Application Recovery Manager uses the TCP/IP protocol for network communications
and must be installed and configured on every client in the cell.
Entering a command using the Application Recovery Manager user interface
establishes a connection to the Cell Manager through the TCP/IP protocol.
The TCP/IP protocol is a group of related protocols and utilities used for network
communications. It consists of the TCP (Transmission Control Protocol) and the IP
(Internet Protocol).
The TCP/IP software is installed on a hard disk, and each computer that uses this
protocol must have the following addresses, usually assigned by the network
administrator:
• The IP address for each network adapter card installed on the computer. This
is a 32-bit number, usually displayed in the dotted quad or dotted decimal format.
Appendix B170