HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

2. In the Specify Source window, select Network Directory/CDROM, and then
enter:
• On a PA-RISC based HP-UX:
Mountpoint/APPRM_DEPOT/APPRM_A0610_UX11x.sd_depot
• On a IA-64 based HP-UX:
Mountpoint/APPRM_DEPOT/APPRM_A0610_UXia64.sd_depot
in the Source Depot Path. Then click OK to open the SD Install - Software
Selection window.
3. In the list of available software packages for the installation, the Application
Recovery Manager product is displayed under the name T5404A. Double-click
it to display the APPRM product for UNIX. Double-click it to display the contents.
The following subproducts are included in the product:
OB2-CM Cell Manager software
OB2-DOCS Application Recovery Manager documentation subproduct
that includes Application Recovery Manager manuals in PDF
format and online Help (WebHelp).
4. Right-click APPRM, and then click Mark for Install to install the whole software.
In case you do not need all subproducts, double-click APPRM and then right-click
an item from the list. Click Unmark for Install to exclude the package or Mark
for Install to select it for installation.
Make sure that the Marked? status value next to the OB2-CM package is set to
Yes if you are installing the Cell Manager for UNIX on the system. Refer to
Figure 44 on page 169.
NOTE:
If you are using user IDs longer than 32 bits, you must remotely install the
User Interface component (OMNI-CS) on the Cell Manager after you have
installed the Core Cell Manager software component.
5. In the Actions list, click Install (analysis), then click OK to proceed. If the Install
(analysis) fails, displaying an error message, click Logfile to view the file.
Appendix B168