HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

This command displays all installed licenses. If the password you entered is not
correct, it is listed with the remark Password could not be decoded.
Finding the number of installed licenses
Using the GUI
Once you have installed a permanent password, you can check how many licenses
are currently installed on the Cell Manager:
1. Start the Application Recovery Manager GUI.
2. In the menu bar, click Help, and then About. The About Manager window will
open, displaying the installed licenses.
Using the CLI
If you use the command line, proceed as follows:
1. Log on to the Cell Manager.
2. Run the following command:
• On Windows: AppRM_home\bin\omnicc -query
• On UNIX: /opt/omni/bin/omnicc -query
A table listing the currently installed licenses will be displayed.
Moving licenses to another Cell Manager System
You must contact the HP Password Delivery Center in any of the following cases:
• If you wish to move the Cell Manager to another system.
• If you plan to move a license, installed on a Cell Manager not currently in use in
the cell, to another Application Recovery Manager cell.
NOTE:
It is possible to move a UNIX license to another UNIX Cell Manager or to a Windows
Cell Manager, but it is not possible to move a Windows license to a UNIX Cell Manager.
Use the following process to move licenses from one Cell Manager to another:
Application Recovery Manager licensing146