HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)
Limitations
For HP OpenView AutoPass, the following limitations apply:
• The HP OpenView AutoPass utility is not installed on Windows x64 operating
systems.
• It is not recommended to install the HP OpenView AutoPass utility in Microsoft
Cluster, because it will be installed only on one node and not on all nodes.
For additional prerequisites and limitations, refer to the HP OpenView AutoPass
licensing guide.
The passwords are installed on the Cell Manager and are valid for the entire cell.
Procedure
The following is the procedure to obtain and install a permanent password:
1. Gather the information required to obtain a permanent password. Refer to the
HP OpenView AutoPass licensing guide to see what information is required.
2. Order the password online using the HP OpenView AutoPass utility. To start the
HP OpenView AutoPass utility, run the following command on the Cell Manager:
/opt/omni/sbin/omniinstlic (UNIX Cell Manager) or
AppRM_home\bin\omniinstlic (Windows Cell Manager)
For more information on the omniinstlic command refer to its man page.
3. Follow the HP OpenView AutoPass utility wizard and enter the required
information.
In the last step of the wizard, clicking Get password will transfer permanent
passwords for the purchased licenses from the HP Password Delivery Center to
the Cell Manager.
Clicking Finish will install permanent passwords for the purchased licenses on
the Cell Manager.
4. To verify the installed passwords, refer to “Verifying the password” on page 145
for instructions.
Other ways of obtaining and installing permanent passwords
Obtaining
The following is the procedure to obtain permanent passwords:
Application Recovery Manager licensing142