HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)
4. The Installation status page is displayed. Click Next.
Figure 39 Installation status page
5. To start using Application Recovery Manager immediately after setup, select
Start the Application Recovery Manager Manager GUI.
To view the HP Application Recovery Manager software product announcements,
software notes, and references, select Open the Product Announcements.
It is not recommended to install the HP OpenView AutoPass utility on Microsoft
Cluster Server, because it will be installed only on one node and not on all
nodes. However, if you install AutoPass, you must uninstall Application Recovery
Manager from the same node on which it was installed, when you decide to
remove Application Recovery Manager from the system.
Click Finish.
NOTE:
If you are upgrading cluster-aware clients, first upgrade every cluster node separately,
and then re-import the virtual server. The remote upgrade is not supported.
Installation and licensing guide 131