HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Upgrade procedure
To upgrade the Windows Cell Manager and Installation Server to Application
Recovery Manager A.06.10, follow the procedure described below:
1. Insert the Windows installation CD-ROM and run the \i386\setup.exe
command. Setup detects the old Application Recovery Manager installation.
Click Next to start the upgrade.
2. In the Component Selection page, the components previously installed on the
system are selected. Note that you can change the component set by selecting
or deselecting additional components. For a description of selected components,
refer to the next step of the wizard. Click Next.
3. If Application Recovery Manager detects Windows Firewall on your system, the
Windows Firewall configuration page is displayed. Application Recovery
Manager setup will register all necessary Application Recovery Manager
executables. By default, the Initially, enable newly registered
Application Recovery Manager binaries to open ports as
needed option is selected. If you do not want to enable Application Recovery
Manager to open ports at the moment, deselect the option. However, note that
for proper functioning of Application Recovery Manager, the executables must
be enabled.
Click Next.
Upgrading to Application Recovery Manager A.06.10124