HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

5. In the Custom Setup window, select the components you want to add and/or
unselect the software components you want to remove. Click Next.
6. Click Install to start the installing or removing the software components.
7. When the installation is completed, click Finish.
Cluster-Aware clients
If you are changing the Application Recovery Manager software components on the
cluster-aware clients, it must be done locally, from the CD-ROM, on each cluster
node. After that, the virtual server hostname has to be manually imported to the
Application Recovery Manager cell using the GUI.
On HP-UX systems
You can add new components using the Installation Server functionality. On an HP-UX
system, some Application Recovery Manager software components depend on each
other and cannot operate properly, if you remove one of them. The table below
presents the components and their dependencies on each other:
Table 7 Application Recovery Manager software component
dependencies on HP-UX
Depend onComponents
OMNI-COREOMNI-CC, OMNI-CORE-IS
OMNI-CORE, OMNI-CCOMNI-CS
Procedure
Perform the following procedure to remove Application Recovery Manager software
components:
1. Log in as root and run the swremove command.
2. Double-click T5404A, APPRM, and then OB2-CM to display a list of the
Application Recovery Manager components.
3. Select the components you want to remove.
4. In the Actions menu, click Mark for Remove to mark the components you want
to remove.
5. When the components you want to remove are marked, click Remove in the
Actions menu, and then click OK.
Maintaining the installation118