HP Application Recovery Manager software A.06.10 Installation and licensing guide (March 2008)

Prerequisites
Before you uninstall the Application Recovery Manager software from a computer,
check the following:
• Make sure that all references to the computer are removed from the backup
specifications. Otherwise, Application Recovery Manager will try to back up
unknown systems and this part of the backup specification will fail. Refer to online
Help index: “modifying, backup specification” for instructions on how to modify
backup specifications.
• Make sure that no disk arrays are connected and configured on the system that
you want to uninstall. Once the system is exported, it cannot access the disk array
or the VSS functionality.
Uninstalling an Application Recovery Manager client
NOTE:
The remote uninstallation procedure requires the Installation Server to be installed.
You uninstall a client remotely by performing these steps in the Application Recovery
Manager GUI:
1. In the Context List, switch to the Clients context.
2. In the Scoping Pane, expand Clients, right-click the client you want to uninstall,
and then click Delete. You will be asked if you want to uninstall the Application
Recovery Manager software as well.
3. Click Yes to uninstall all the software components from the client, and then click
Finish.
The client will be removed from the list in the Results Area and the Application
Recovery Manager software will be deleted from its hard disk.
Note that the Application Recovery Manager configuration data remains on the client
system. If you want to remove the configuration data, delete the directories where
Application Recovery Manager was installed.
Uninstalling Application Recovery Manager also removes the Java GUI Client. Unless
the Permanently delete configuration data checkbox is selected when uninstalling
Application Recovery Manager, the Java GUI configuration data remains on the
system.
Installation and licensing guide 113