HP Application Recovery Manager software A.06.10 Command line interface reference (March 2008)

VSS_Options

-conf_check {strict | non-strict | disabled}

Sets the configuration check mode. If the check fails, the instant recovery session

will fail. Select the strict mode to check each file or directory. Select the

non-strict mode to check each folder. Disable configuration check only if

instant recovery cannot be performed with an enabled configuration check and

only if you are sure that this will not result in a loss of data during the instant

recovery. In this case, you will lose the data that does not belong to a component,

but resides on the same volume.

-use_vds

Switches a replica from the specified backup session with the source volume.

Once switched, the replica is not available for another instant recovery session

and also information about this replica is deleted from the database (VSSDB).

Does not use a ZDB array specific options or agents. This option must be used

after the backup created with the XP provider in the VSS compliant mode.

-no_retain_source

Overwrites the source volume during the switch or copy process.

Caution: If this option is specified and the instant recovery session fails, the

original data on the source volume will be lost.

Important: In the case of restore using HP StorageWorks Disk Array XP (after the

backup created with the XP provider in the resync mode), this option must be

specified since there is no possibility to retain the source during re-synchronization

of replica and source disks.

-manual_restore ScriptName

Executes a custom script instead of performing instant recovery. The script must

reside on the application system in the directory AppRM_home\bin, and must

exit with the exit code 0 in order to enable successful session completion.

-no_recovery

Leaves the application database in the recovery mode after completion of the

instant recovery session, enabling you to manually apply transaction logs to the

database.

Exchange_Specific_Options

-exch_check

Performs the consistency check of the Microsoft Exchange Server database

replicated datafiles. The Microsoft Exchange Server database backup is

considered as successful only if the consistency check succeeds. Use this option

if consistency check was not performed during backup.

-exch_throttle Value