HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Maintaining the Installation
Changing Application Recovery Manager Software Components
Chapter 378
Changing Application Recovery Manager
Software Components
This section describes the procedure for removing and adding
Application Recovery Manager software components. For the list of
supported Application Recovery Manager components, refer to
http://www.hp.com/support/manuals
.
Application Recovery Manager software components can be added on the
Cell Manager or on a client using the Application Recovery Manager
GUI. You perform the remote installation of selected components using
the Installation Server functionality. For the detailed procedure refer to
“Remote Installation of Application Recovery Manager Clients” on
page 29.
The Application Recovery Manager components can be removed locally
on the Cell Manager or on a client.
To add or remove the Application Recovery Manager software
components, follow the steps below:
1. In the Windows Control Panel, click Add or Remove Programs.
2. Select HP StorageWorks Application Recovery Manager A.06.00
and click Change.
3. Click Next.
4. In the Program Maintenance window, click Modify and then Next.
5. In the Custom Setup window, select the components you want to add
and/or unselect the software components you want to remove. Click
Next.
6. Click Install to start the installing or removing the software
components.
7. When the installation is completed, click Finish.
Cluster-Aware
Clients
If you are changing the Application Recovery Manager software
components on the cluster-aware clients, it must be done locally, from the
CD-ROM, on each cluster node. After that, the virtual server hostname
has to be manually imported to the Application Recovery Manager cell
using the GUI.