HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing Application Recovery Manager on Microsoft Cluster Server
Chapter 248
NOTE You can import a cluster-aware client to the Application Recovery
Manager cell that is managed using either the standard Cell Manager or
the cluster-aware Cell Manager.
Checking the
Installation
When the setup procedure has been completed, you can check whether or
not the Application Recovery Manager software has been properly
installed. Proceed as follows:
1. Check if the Cluster service account is assigned to the Application
Recovery Manager Inet service on each cluster node. Make sure the
same user is also added to the Application Recovery Manager admin
user group. The logon account type should be set to This account as
shown in Figure 2-22.
Figure 2-22 Application Recovery Manager User Account
2. Switch to the <AppRM_home>\bin directory.
3. Run the following command:
omnirsh <host> INFO_CLUS