HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing Application Recovery Manager on Microsoft Cluster Server
Chapter 240
Installing Application Recovery Manager on
Microsoft Cluster Server
For supported operating systems for Microsoft Cluster Server
integration, see the http://www.hp.com/support/manuals
.
If your Cell Manager is to be cluster-aware, note that the virtual server
IP address should be used for licenses.
Installing a Cluster-Aware Cell Manager
Prerequisites Before you install the cluster-aware Cell Manager, make sure that you
do not have resources with the following names on the cluster:
OBVS_MCRS,OBVS_VELOCIS,OmniBack_Share
If they exist and you are performing a new installation, delete or rename
these resources, because Application Recovery Manager uses those
names for the Application Recovery Manager virtual server.
This can be done as follows:
1. Click Start ->Programs -> Administrative Tools -> Cluster
Administrator.
2. Check the resource list and delete or rename these resources, if
necessary.
To properly install and configure Application Recovery Manager in a
Microsoft Cluster Server environment, you must provide a domain
account with the appropriate user rights:
Administrator rights on the Cell Manager
Cluster Administrator rights within the cluster
Password Never Expires
Logon as a service
User Cannot Change Password
All logon hours are allowed