HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Installing Application Recovery Manager on Your Network
Installing the Application Recovery Manager Cell Manager (CM) and Installation
Server(s) (IS)
Chapter 2 17
Figure 2-3 Selecting Software Components
User Interface, Installation Server, and Microsoft Volume
Shadow Copy Integration are selected by default. Click Next.
7. Windows 2003 SP1: If Application Recovery Manager detects
Windows Firewall on your system, the Windows Firewall
configuration page is displayed. Application Recovery Manager setup
will register all necessary Application Recovery Manager executables.
By default, the selected option is Initially, enable newly
registered Application Recovery Manager binaries to open
ports as needed. If you do not want to enable Application Recovery
Manager to open ports at the moment, deselect the option. However,
note that for proper functioning of Application Recovery Manager, the
executables must be enabled.
Click Next.
8. The component summary list is displayed. Click Install to start
installing the selected components. This may take several minutes.