HP StorageWorks Application Recovery Manager Installation and Licensing Guide (T4395-96002, February 2008)

Application Recovery Manager Licensing
Application Recovery Manager Passwords
Chapter 492
• You need the IP address of the Cell Manager.
Limitations For HP OpenView AutoPass, the following limitations apply:
• The HP OpenView AutoPass utility is not installed on Windows x64
operating systems.
•It is not recommended to install the HP OpenView AutoPass utility in
Microsoft Cluster, because it will be installed only on one node and
not on all nodes.
For additional prerequisites and limitations, refer to the HP OpenView
AutoPass Licensing Guide.
The passwords are installed on the Cell Manager and are valid for the
entire cell.
Procedure The following is the procedure to obtain and install a permanent
password:
1. Gather the information required to obtain a permanent password.
Refer to the HP OpenView AutoPass Licensing Guide to see what
information is required.
2. Order the password online using the HP OpenView AutoPass utility.
To start the HP OpenView AutoPass utility, run the following
command on the Cell Manager:
<AppRM_home>\bin\omniinstlic
3. Follow the HP OpenView AutoPass utility wizard and enter the
required information.
In the last step of the wizard, clicking Get password will transfer
permanent passwords for the purchased licenses from the HP
Password Delivery Center to the Cell Manager.
Clicking Finish will install permanent passwords for the purchased
licenses on the Cell Manager.
4. To verify the installed passwords, refer to “Verifying the Password” on
page 95 for instructions.