HP StorageWorks Application Recovery Manager Command Line Interface Reference (T4395-96007, December 2007)

omnir (1)
-41-Hewlett-Packard Company AppRM A.06.00: December 2007
replica is deleted from the database (VSSDB). Does not use a ZDB
array specific options or agents. This option must be used after the
backup created with the XP provider in the VSS compliant mode.
Exchange_Specific_Options
-exch_throttle value Throttles down the consistency check to lessen impact on
backup/restore performance. Set the number of input/output
operations, after which the check is stopped for one second.
-exch_check Performs the consistency check of the Microsoft Exchange Server
database replicated datafiles. The Microsoft Exchange Server
database backup is considered as successful only if the consistency
check succeeds. Use this option if consistency check was not
performed during backup.
Exchange_2007_specific_options
-appsrv HostName Specifies the system to which the components are restored. If
not specified, the components are always restored to the server
from where they were backed up. Note that all objects in one
restore session must be restored to the same system.
-target_tree TargetTreeName Specifies the target component to which the
source component will be restored and enables you to restore a
subcomponent to a different component than the one from which it
was backed up. This option can be used only once for each -tree
option and cannot be specified together with -exch_RSG.
TreeName and its TargetTreeName pair must always be fully
expanded subcomponents representing an Exchange store or logs.
See also the Exchange 2007 examples. To get a list of available
targets on a specific host, run the command:
vssbar -appsrv:HostName -perfom:browse -all
Potential targets can be identified by the string “RESTOREMODE =
1”.
NOTE: You cannot restore only a store without logs to a different
location. If you specify a target store for an original store, you must
also specify logs with an additional -tree TreeName
-target_tree TargetTreeName pair. This limitation does not
apply if you restore only the logs to a different location.
The option must be specified together with -target_dir.