HP StorageWorks Application Recovery Manager Command Line Interface Reference (T4395-96007, December 2007)

omnir (1)
-40- Hewlett-Packard CompanyAppRM A.06.00: December 2007
OPTIONS
-version Displays the version of the omnir command
-help Displays the usage synopsis of the omnir command
-vss Selects the VSS object for restore
-session SessionID Specifies the session to be used for restore.
-tree TreeName Specifies the component or tree to restore. Note that trees must
be specified without volumes (drives). For example: -tree /
Filesystem/E.
-barhost ClientName Specifies the system where the VSS agent is run.
VSS_Options
-conf_check {strict | non-strict | disabled} Sets the configuration
check mode. If the check fails, the instant recovery session will fail.
Select the strict mode to check each file or directory. Select the
non-strict mode to check each folder. Disable configuration check
only if instant recovery cannot be performed with an enabled
configuration check and only if you are sure that this will not
result in a loss of data during the instant recovery. In this case, you
will lose the data that does not belong to a component, but resides
on the same volume.
-no_retain_source Overwrites the source volume during the switch or copy (or
re-synchronization) process.
Warning: If you specify this option and the instant recovery session
fails, the original data on the source volume will be lost.
Important: In the case of restore using HP StorageWorks disk
array XP (after the backup created with the XP provider in the
resync mode), this option must be specified since there is no
possibility to retain the source during re-synchronization of replica
and source disks.
-no_recovery If this option is selected, Application Recovery Manager enables
you to apply transaction logs on the SQL Server after instant
recovery.
-use_vds Switches a replica from the specified backup session with the
source volume. Once switched, the replica is not available for
another instant recovery session and also information about this